Subsurface flow measurements using passive flux meters in variably-saturated cold-regions landscapes     

Élise G. Devoie  Ryan F. Connon  James R. Craig  William L. Quinton 《水文研究》2020,34(23):4541-4546

To date, passive flux meters have predominantly been applied in temperate environments for tracking the movement of contaminants in groundwater. This study applies these instruments to reduce uncertainty in (typically instantaneous) flux measurements made in a low-gradient, wetland dominated, discontinuous permafrost environment. This method supports improved estimation of unsaturated and over-winter subsurface flows which are very difficult to quantify using hydraulic gradient-based approaches. Improved subsurface flow estimates can play a key role in understanding the water budget of this landscape.  相似文献   

Solution for a plane strain rough‐walled hydraulic fracture driven by turbulent fluid through impermeable rock          下载免费PDF全文

N. Zolfaghari  E. Dontsov  A. P. Bunger 《国际地质力学数值与分析法杂志》2018,42(4):587-617

The impact of turbulent flow on plane strain fluid‐driven crack propagation is an important but still poorly understood consideration in hydraulic fracture modeling. The changes that hydraulic fracturing has experienced over the past decade, especially in the area of fracturing fluids, have played a major role in the transition of the typical fluid regime from laminar to turbulent flow. Motivated by the increasing preponderance of high‐rate, water‐driven hydraulic fractures with high Reynolds number, we present a semianalytical solution for the propagation of a plane strain hydraulic fracture driven by a turbulent fluid in an impermeable formation. The formulation uses a power law relationship between the Darcy‐Weisbach friction factor and the scale of the fracture roughness, where one specific manifestation of this generalized friction factor is the classical Gauckler‐Manning‐Strickler approximation for turbulent flow in a rough‐walled channel. Conservation of mass, elasticity, and crack propagation are also solved simultaneously. We obtain a semianalytical solution using an orthogonal polynomial series. An approximate closed‐form solution is enabled by a choice of orthogonal polynomials embedding the near‐tip asymptotic behavior and thus giving very rapid convergence; a precise solution is obtained with 2 terms of the series. By comparison with numerical simulations, we show that the transition region between the laminar and turbulent regimes can be relatively small so that full solutions can often be well approximated by either a fully laminar or fully turbulent solution.  相似文献   

Geostatistical features of streambed vertical hydraulic conductivities in Frenchman Creek Watershed in Western Nebraska     

Olufemi P. Abimbola  Aaron R. Mittelstet  Troy E. Gilmore 《水文研究》2020,34(16):3481-3491

This study evaluated the spatial variability of streambed vertical hydraulic conductivity (K_v) in different stream morphologies in the Frenchman Creek Watershed, Western Nebraska, using different variogram models. Streambed K_v values were determined in situ using permeameter tests at 10 sites in Frenchman, Stinking Water and Spring Creeks during the dry season at baseflow conditions. Measurements were taken both in straight and meandering stream channels during a 5 day period at similar flow conditions. Each test site comprised of at least three transects and each transect comprised of at least three K_v measurements. Linear, Gaussian, exponential and spherical variogram models were used with Kriging gridding method for the 10 sites. As a goodness-of-fit statistic for the variogram models, cross-validation results showed differences in the median absolute deviation and the standard deviation of the cross-validation residuals. Results show that using the geometric means of the 10 sites for gridding performs better than using either all the K_v values from the 93 permeameter tests or 10 K_v values from the middle transects and centre permeameters. Incorporating both the spatial variability and the uncertainty involved in the measurement at a reach segment can yield more accurate grid results that can be useful in calibrating K_v at watershed or sub-watershed scales in distributed hydrological models.  相似文献   

P‐wave transmission across fractures with nonlinear deformational behaviour     

X. B. Zhao  J. Zhao  J. G. Cai 《国际地质力学数值与分析法杂志》2006,30(11):1097-1112

Stress wave attenuation across fractured rock masses is a great concern of underground structure safety. When the wave amplitude is large, fractures experience nonlinear deformation during the wave propagation. This paper presents a study on normal transmission of P‐wave across parallel fractures with nonlinear deformational behaviour (static Barton–Bandis model). The results show that the magnitude of transmission coefficient is a function of incident wave amplitude, nondimensional fracture spacing and number of fractures. Two important indices of nondimensional fracture spacing are identified, and they divide the area of nondimensional fracture spacing into three parts (individual fracture area, transition area and small spacing area). In the different areas, the magnitude of transmission coefficient has different trends with nondimensional fracture spacing and number of fractures. In addition, the study reveals that under some circumstances, the magnitude of transmission coefficient increases with increasing number of fractures, and is larger than 1. Copyright © 2006 John Wiley & Sons, Ltd.  相似文献   

Seasonal variations in prey selection by estuarine black-headed gulls (Larus ridibundus)     

D.J. Curtis  C.G. Galbraith  J.C. Smyth  D.B.A. Thompson 《Estuarine, Coastal and Shelf Science》1985,21(1):75-90

The number of black-headed gulls (Larus ridibundus) in the Clyde Estuary is large. In summer the average density has reached 1350 gulls km^?2 and in winter 180 gulls km^?2. This paper compares prey selection and feeding efficiency in gulls during summer and winter on tidal flats, and considers how seasonal differences may be adaptations to cope with seasonal changes in prey availability.Gross and net rates of energy intake were highest in summer because gulls captured more of the polychaete N. diversicolor than the amphipod C. volutator. In winter, gulls selected for C. volutator and therefore an energetically less profitable diet. Throughout the year gulls selected more C. volutator relative to N. diversicolor than expected on energetic grounds and so apparently did not maximize potential net rate of energy intake.Gulls used three techniques to capture prey and made most intensive use of the ‘crouch’ technique. Crouching gulls attained a much higher net rate of energy intake than ‘upright’ or ‘paddling’ gulls.A log-linear model showed that (a) season, water depth and gull density determined feeding technique and (b) feeding technique and season independently determined foraging success and prey selection. Thus gull density and water depth acted on prey selection through imposed variations in feeding technique.Reasons for gulls selecting energetically unprofitable C. volutator and for the use of several distinct feeding techniques are discussed.  相似文献   

Generalized strain probing of constitutive models     

Youssef M. A. Hashash  Qingwei Fu  Jeremy Butkovich 《国际地质力学数值与分析法杂志》2004,28(15):1503-1519

Advanced material constitutive models are used to describe complex soil behaviour. These models are often used in the solution of boundary value problems under general loading conditions. Users and developers of constitutive models need to methodically investigate the represented soil response under a wide range of loading conditions. This paper presents a systematic procedure for probing constitutive models. A general incremental strain probe, 6D hyperspherical strain probe (HSP), is introduced to examine rate‐independent model response under all possible strain loading conditions. Two special cases of HSP, the true triaxial strain probe (TTSP) and the plane‐strain strain probe (PSSP), are used to generate 3‐D objects that represent model stress response to probing. The TTSP, PSSP and general HSP procedures are demonstrated using elasto‐plastic models. The objects resulting from the probing procedure readily highlight important model characteristics including anisotropy, yielding, hardening, softening and failure. The PSSP procedure is applied to a Neural Network (NN) based constitutive model. It shows that this probing is especially useful in understanding NN constitutive models, which do not contain explicit functions for yield surface, hardening, or anisotropy. Copyright © 2004 John Wiley & Sons, Ltd.  相似文献   

A micromechanical finite element model for linear and damage‐coupled viscoelastic behaviour of asphalt mixture     

Qingli Dai  Martin H. Sadd  Zhanping You 《国际地质力学数值与分析法杂志》2006,30(11):1135-1158

This study presents a finite element (FE) micromechanical modelling approach for the simulation of linear and damage‐coupled viscoelastic behaviour of asphalt mixture. Asphalt mixture is a composite material of graded aggregates bound with mastic (asphalt and fine aggregates). The microstructural model of asphalt mixture incorporates an equivalent lattice network structure whereby intergranular load transfer is simulated through an effective asphalt mastic zone. The finite element model integrates the ABAQUS user material subroutine with continuum elements for the effective asphalt mastic and rigid body elements for each aggregate. A unified approach is proposed using Schapery non‐linear viscoelastic model for the rate‐independent and rate‐dependent damage behaviour. A finite element incremental algorithm with a recursive relationship for three‐dimensional (3D) linear and damage‐coupled viscoelastic behaviour is developed. This algorithm is used in a 3D user‐defined material model for the asphalt mastic to predict global linear and damage‐coupled viscoelastic behaviour of asphalt mixture. For linear viscoelastic study, the creep stiffnesses of mastic and asphalt mixture at different temperatures are measured in laboratory. A regression‐fitting method is employed to calibrate generalized Maxwell models with Prony series and generate master stiffness curves for mastic and asphalt mixture. A computational model is developed with image analysis of sectioned surface of a test specimen. The viscoelastic prediction of mixture creep stiffness with the calibrated mastic material parameters is compared with mixture master stiffness curve over a reduced time period. In regard to damage‐coupled viscoelastic behaviour, cyclic loading responses of linear and rate‐independent damage‐coupled viscoelastic materials are compared. Effects of particular microstructure parameters on the rate‐independent damage‐coupled viscoelastic behaviour are also investigated with finite element simulations of asphalt numerical samples. Further study describes loading rate effects on the asphalt viscoelastic properties and rate‐dependent damage behaviour. Copyright © 2006 John Wiley & Sons, Ltd.  相似文献   

不同粘土矿物水敏性特征   总被引：2，自引：2，他引：0  

韩志勇  郑西来  陈继红 《水文地质工程地质》2008,35(1):80-82

通过改变砂样中的粘土矿物的种类和含量,结合咸淡水之间的单一和驱替实验,研究不同粘土矿物的水敏性特征。在单一的咸水和淡水情况下,当砂柱中的粘粒含量≤1.5%(重量比)时,其渗透系数基本不发生改变,即使粘粒含量从1.5%增加10%,其渗透系数也仅下降约一个数量级。各种粘土矿物中,蒙脱石导致含水介质渗透系数的下降最为明显,高岭土和伊利石约是其影响值的一半。咸淡水驱替实验中,加入蒙脱石颗粒的砂柱的渗透系数急剧下降,当蒙脱石含量达3~4%时,渗透系数已经下降的极低,可以看作不透水层,而加入高岭土和伊利石的砂柱的渗透系数没有急剧变化。对于这种现象的解释是:不同类型的粘土颗粒吸附不同数量的水分子,形成数量和大小不同的胶体团,使得介质渗透系数的变化量不同。  相似文献   

GYD-300型全液压动力头工程钻机的研制     

靳益民  高淑芳 《探矿工程》2008,35(12):23-25,34

GYD-300型全液压动力头工程钻机为全液压驱动,动力头反循环式机型。液压系统采用插装阀集成结构,电液复合操作。使用PC控制监测系统,适时检测孔底各相关压力,对不同地层进行范围设置,实现钻进过程中孔底的自动、手动恒压钻进。重点介绍了该钻机的结构特点、实验情况、主要技术参数等。  相似文献   

Transplantation-tagging-experiments in preliminary studies of migration of cod off Norway   总被引：1，自引：2，他引：1  

Godo  Olav Rune 《ICES Journal of Marine Science》1995,52(6):955-962

  相似文献